G'day all, I have been lurking around this very informative forum for ages but now I am looking for a little advice.
I have removed an internal wall which leaves a gap in the flooring. I am going to fill the gap with a single board laid at a right angle to the existing flooring. I have to trim the existing flooring to square it up and this looks like I might be cutting through a few nails as well. I figure that there should be a circular saw blade out there that will do that job. My real problem is when I reach the wall that runs parallel to the existing floor. The circular saw will not reach the wall leaving 1 or more floorboards not trimed. Any ideas on what tool or tools that I can use to complete the cut.


Read the full thread at RenovateForum.com...