Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
23rd December 2012, 04:50 PM #1
LVL size for 3m load bearing wall
Hi folks,
I'm about to remove a 3m what appears to be load bearing wall and would appreciate a couple of opinions re LVL size.
I've had a look at a couple of span tables but would like to be sure.
The house is a simple 1960s 12 x 6m hard wood framed, chamfer and fibro in Brisbane. It has a 10 degree fibro roof which looks hand-built in hardwood .
There are parallel beams in the roof running the full 12m about 1200mm out from the ridge - I'm assuming this is the load point on the internal walls below?
The 4 x 2s that span the 6m across and just above the ceiling battens are spaced at 900mm centres along the 12m.
Lower garage has concrete stumps supporting 3 - 6 x 3 bearers with 6 x 2 joists across, double joists under all internal walls.
The wall to be removed is the one behind the couch, I'm assuming the wall that runs up the center of the house under the ridge is non load bearing?
Sorry to chop and change beetween imperial and metric...as a picture framer i work in mm, as an owner builder i work in cm and metres, when my dad is helping its all feet and inches!! as it was when the house was built.
hope this all makes sense and look forward to your replies
Attached Thumbnails
Read the full thread at RenovateForum.com...
-
23rd December 2012 04:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
bearing pre load
By morrisman in forum METALWORK FORUMReplies: 12Last Post: 4th November 2011, 03:52 PM -
bearing size
By weisyboy in forum METALWORK FORUMReplies: 7Last Post: 16th June 2008, 08:45 AM -
Calculating Roof weight on load bearing wall.
By sydneymick in forum WOODWORK - GENERALReplies: 5Last Post: 22nd August 2007, 12:20 AM