Thread: mitre angle??

I have a rafter @ 5500mm long with a fall of 200mm over entire length

before you cut that rafter, what are you covering the roof with?
if it's wriggly tin (corrugated iron) a 1 in 28 fall is lot less than the recommended minimum of 1 in 12


ian

Thanks Ian.
I am researching for a mate. I will ask what he is going to cover it with.
Regards,
Sandman

angle =acos(adjacent/hypotenuse)
= acos(200/5500)
= 87.9 degrees

On MS scientific calculator (press each button as below)
Make sure degrees is selected.

200 / 5500 =

tick box "inv" then press the cos button

if ms calc does not have all the bttons select "view" then "scientific"

A bit confused here, are you talking about a common rafter side cut?
Or your use of mitre makes me think you might want the jack rafter top cut. If that's the case it's so close to 45deg it doesn't matter.

If it is your side cut, as already posted by Ivan, it is say 88 deg which is a two degree pitch, and custom orb requires 5 deg minimum as Ian has already pointed out.

Klip-Lok 406 0.42 will do a 2deg pitch and the thicker stuff will go down to one degree.

Cheers
Bill

Try this

http://www.blocklayer.com/roof