Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
1st June 2009, 02:40 PM #1
240V 2xinput -> 1 output selector switch..?
Unfortunately I'm a bit short on time to go web browsing trying to find what I'm after atm, especially if I'm not sure of what it's exactly called. I'm hoping to leverage the existing knowledge in this forum for what's available as an option and what the device is called so I can do further searches.
I'm after a device that will take two 240V inputs and via a dial/button/switch selector allow me to select any one those 240V lines as output. Must be rated to a min of 15A. Also would be great if there was a simlpe enclosure available for it.
Depending on the cost it might be nice if it had a timer function to switch inputs at predefined times, for eg 1pm-3pm input 1 is selected and the rest of the time input 2 is selected. I have a feeling the timer version is going to cost more than I'm willing to spend so the priority should be on the manual version but out of interest if you also have a timer version I'm curious. Note in reality I don't need a timer version with a million and one time combo's. Just two will be enough that will work like my example above, that is, during this time use input X, during others use input Y.
Any suggestions?
Many Thanks.
M
Read the full thread at RenovateForum.com...
-
1st June 2009 02:40 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
Triton router plunge selector button stuck in
By completeamateur in forum TRITON / GMCReplies: 1Last Post: 7th December 2008, 09:21 PM -
safe to divert evap aircon output to rainwater tank??
By ubeaut in forum HEATING & COOLINGReplies: 0Last Post: 16th November 2008, 07:10 AM -
'New'? 10amp 240v remote switch
By bsrlee in forum GENERAL & SMALL MACHINERYReplies: 9Last Post: 23rd May 2008, 10:20 AM -
Leda power output--SKEW?
By lubbing5cherubs in forum WOODTURNING - GENERALReplies: 24Last Post: 18th September 2007, 09:39 PM -
Side play in plunge drill output shaft
By glynhouse in forum TRITON / GMCReplies: 0Last Post: 11th January 2007, 10:42 PM