Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
31st March 2009, 11:50 AM #1
Correct method for tightening toilet service nut?
Renovating a bathroom and reinstalled the toilet with no problems except.....
Can someone tell me the correct way to connect the 'service nut' on the inlet!
I'm using a new inlet valve (with plastic thread) and a new nylon service nut and nylon olive washer. The inlet pipe is chrome plated copper.
I've had to take the toilet in and out a couple of times, and I always have trouble getting the inlet service nut joint to seal properly. Often get a very slight leak. Right now its leaking slightly between the thread and nut.
Specifics..
1. Should you use thread tape?
2. Should it be finger tight (as in the instructions with the inlet valve) or spanner tight
3. should I use a new olive washer every time it is disconnected
etc etc
Normally I dont have problems with normal brass/copper compression joints but this nylon one always gives me grief!
Any tips would be much appreciated.
Steve
Read the full thread at RenovateForum.com...
-
31st March 2009 11:50 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
What method have you used to find the correct workbench height for you?
By WoodworkLady in forum THE WORK BENCHReplies: 37Last Post: 28th September 2008, 11:49 AM -
BELT SANDER - needs tightening HELP!
By doctorpaul in forum HAND TOOLS - POWEREDReplies: 9Last Post: 25th September 2008, 12:35 AM -
keyless self tightening chuck
By hughie in forum WOODTURNING - GENERALReplies: 10Last Post: 30th August 2006, 02:40 PM -
MC900 belt tightening
By reeves in forum WOODTURNING - GENERALReplies: 13Last Post: 12th April 2005, 01:18 AM