Needs Pictures: 0
Results 31 to 34 of 34
Thread: Electrical Sub board in shed.
-
4th March 2017, 08:35 PM #31
-
4th March 2017 08:35 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
5th March 2017, 08:47 AM #32Woodworking mechanic
- Join Date
- Jan 2014
- Location
- Sydney Upper North Shore
- Posts
- 4,470
Just a bit more info on these contemplating doing the same as me.
The reason I asked re the 6mm twin + earth TPS was not regarding the wire size but rather the wire configuration. One guy wanted to run 6mm SDI wires plus an earth which was more expensive.
Cheers
-
5th March 2017, 12:47 PM #33
Two single cores actually increases the current carrying capacity a little bit. He probably has a couple of rolls of 6mm SDI sitting on the shelf. Good opportunity to use it up.
Those were the droids I was looking for.
https://autoblastgates.com.au
-
20th March 2017, 05:01 PM #34Woodworking mechanic
- Join Date
- Jan 2014
- Location
- Sydney Upper North Shore
- Posts
- 4,470
At last a fine day and the sub board is in plus 3 x 15A GPOs. Great guy, will use him again. Less than 1/2 the cost of some of the quotes. One guy quoted 3 days labour, this guy and his mate arrived at 10:15 and out at 1:45pm.
IMG_0598.jpgIMG_0599.jpgIMG_0600.jpg
Similar Threads
-
Cutting a thicker board, into a thinner board...
By kalium in forum WOODWORK - GENERALReplies: 12Last Post: 19th November 2014, 06:53 PM -
Cheap particle board for shed lining
By needs sandin in forum THE SHEDReplies: 2Last Post: 5th May 2014, 08:03 PM