Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Dynalink spur drive centre
-
25th May 2015, 06:04 PM #1
Dynalink spur drive centre
The a rep from the local mens shed has asked me to find a spur drive for a Dynalink lathe model 190+93-01035. It was given to them. Can anybody tell me where to get that spur drive please?
JimSometimes in the daily challenges that life gives us, we miss what is really important...
-
25th May 2015 06:04 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
25th May 2015, 07:01 PM #2GOLD MEMBER
- Join Date
- Aug 2012
- Location
- Imbil
- Posts
- 1,167
Hi Jim,
I think that lathe is the standard boat anchor type sold under many different brands(thin square tube bed) I have one under the house the son inlaw gave me not sure if I have the spur drive I will have a look in the morning and let you know.
Regards Rod.
-
26th May 2015, 06:37 PM #3
Rod, thanks for the reply. The spur drive is a threaded type, like a nut, not a morse taper. The thread is 20mm, I don't know what the pitch is though.
JimSometimes in the daily challenges that life gives us, we miss what is really important...
-
27th May 2015, 08:15 AM #4GOLD MEMBER
- Join Date
- Aug 2012
- Location
- Imbil
- Posts
- 1,167
Hi Jim,
It took a bit longer than I thought to find the spur but it is now in my hand and as you described screw on type if you could PM me an address I will get it in the post for you.
Regards Rod.
-
27th May 2015, 09:49 AM #5
Thanks Rod, PM sent.
JimSometimes in the daily challenges that life gives us, we miss what is really important...
Similar Threads
-
Gmc spur drive
By Chalkey in forum TRITON / GMCReplies: 3Last Post: 14th April 2015, 06:09 PM -
Spur drive into hard(er) timber?
By Mr Brush in forum WOODTURNING - GENERALReplies: 15Last Post: 22nd December 2010, 09:08 PM -
Mini Spur Drive
By Richard0470 in forum WOODTURNING - GENERALReplies: 2Last Post: 29th January 2009, 11:32 PM -
No 1 Morse Taper Drive Spur
By stevew in forum WOODTURNING - GENERALReplies: 3Last Post: 5th August 2008, 06:10 PM