help with missing Jet part

**Lumber Bunker** · 17th May 2012, 10:11 PM

Perfect!!!

Now to call in a favour.
Thank you so much DJ.

**bassmansimon** · 19th May 2012, 12:48 PM

All measured up on the 1220. Very similar to DJ's. From my (plastic manual calipers) measurements, the only difference was with the screw thread end.

Where DJ's was 29mm mine is 27mm. Total length is 67mm. I don't think the length of the screw thread (or the width for that matter) is particularly important though. The screw thread (exterior) on mine was 9.5mm.

Simon.

**Acco** · 19th May 2012, 02:14 PM

Mine was closer to 27mm but I made it 29mm as I noticed that end was still inside the nut, so a extra couple of mm would make the end flush with the nut

**Lumber Bunker** · 19th May 2012, 08:13 PM

great thanks boys.
So yes they are both the same. file that for future reference.

Thanks again.

Steve

**Lumber Bunker** · 8th June 2012, 07:19 PM

Haha!
Sorted.
Thank you all for your help. Very helpful
And I'm stoked to have the lathe up and running again.

Cheers all.

**bassmansimon** · 8th June 2012, 07:25 PM

Nice work! Looks like good quality workmanship there

**Acco** · 8th June 2012, 07:25 PM

**Lumber Bunker** · 9th June 2012, 10:54 AM

Yeah, it's great workmanship my friend works for an engineering co. In orange. His skills are top notch.

Thread: help with missing Jet part

Thread Tools

Search Thread

Similar Threads

Part two of a four part series, "Routing for beginners"

Part 1 of 3 Part TV Cabinet

4-way tool post, part missing?

Something Missing

Bevel Cut on W/C 2000 - Missing part ?

Tags for this Thread

Posting Permissions