Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 6 of 6
Thread: new lathe
-
2nd August 2012, 09:23 PM #1Novice
- Join Date
- Feb 2011
- Location
- qld australia
- Posts
- 19
new lathe
Hi have not visited for a while, Currently own a cheap GMC Lathe but am now looking at upgrading to better lathe, Just looking for suggestions and thoughts on current Lathes on the market. I currently only do small projects but will look at increasing size of projects once i have a better Lathe.
-
2nd August 2012 09:23 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
2nd August 2012, 09:44 PM #2
Hi Wayne
I have a Nova 1624 lathe I find it very user friendly and big enough to do those slightly larger pieces. It still going for around $1200 to $1300 at Carbatec. Only thing I would say is the stand legs are short so you may need to build a bench top for it to sit on.
I hope this helps.
Cheers Skewturn
-
3rd August 2012, 01:06 AM #3
Well if you can figure out where your going with your turning and what you want to turn etc. Then set your budget and your half way there or at apoint when you will have a few models in mind.
From this point its easy to offer advice, mind you what ever the cost of the lathe is it will end up being the smallest in the end.Inspiration exists, but it has to find you working. — Pablo Picasso
-
3rd August 2012, 10:42 AM #4Novice
- Join Date
- Feb 2011
- Location
- qld australia
- Posts
- 19
thank you for your reply
-
3rd August 2012, 01:29 PM #5
maybe secondhand
Wayne, If your budget is a bit tight try second hand. At the moment theres a few on Ebay that are old but good makes with plenty of capacity and after driving a GMC they will feel like a Mercedes
Inspiration exists, but it has to find you working. — Pablo Picasso
-
3rd August 2012, 06:17 PM #6Novice
- Join Date
- Feb 2011
- Location
- qld australia
- Posts
- 19
Thanks for reply did not think about 2nd hand will have look
Similar Threads
-
HEADS UP Wood lathe:jet 1220 midi lathe
By Woodwarehouse in forum ANNOUNCEMENTSReplies: 0Last Post: 1st December 2011, 03:02 PM -
Converting a Metalworking Lathe to Wood Turning Lathe
By GrinlingGibbons in forum WOODTURNING - GENERALReplies: 13Last Post: 29th March 2011, 07:17 AM -
Buying a lathe (Old massive Lathe, or New small C6 Lathe)
By Ch4iS in forum METALWORK FORUMReplies: 5Last Post: 25th March 2009, 12:19 PM