Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: lathe problems. advise please
-
14th October 2011, 07:21 PM #1
lathe problems. advise please
Hi all
I have a woodfast lathe. Recently I am unable to lock the toolrest on the lathe bed. The mechanism has a springy spongy feel and there is no positive lock. I have tried adjusting the nut underneath, but can't figure out if I should tiggten or loosen
Any comments welcome
Thank u
-
14th October 2011 07:21 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
14th October 2011, 07:59 PM #2
There could be a build up of muck on the bar under the banjo.
Take the whole banjo of the lathe and clean all the parts even take apart if possible.Jim Carroll
One Good Turn Deserves Another. CWS, Vicmarc, Robert Sorby, Woodcut, Tormek, Woodfast
Are you a registered member? Why not? click here to register. It's free and only takes 37 seconds!
-
27th October 2011, 07:39 PM #3
Thanks. That worked I wiped it with white spirit. Works a treat
Sent from my GT-I9000 using Tapatalk
Similar Threads
-
MC1100A Lathe Motor Problems
By Daz-za in forum WOODTURNING - GENERALReplies: 5Last Post: 31st May 2010, 01:11 AM -
Problems With New Lathe
By wm460 in forum METALWORK FORUMReplies: 5Last Post: 21st January 2010, 02:17 PM -
please advise re lathe setup
By jow104 in forum WOODTURNING - GENERALReplies: 28Last Post: 17th December 2009, 07:09 AM -
lathe problems
By ahunter77 in forum METALWORK FORUMReplies: 3Last Post: 11th December 2009, 11:11 PM -
MC1100 lathe motor problems
By GC in forum WOODTURNING - GENERALReplies: 2Last Post: 7th December 2006, 04:55 PM