Thread: natural edge vase

Nice work Ted. Well finished. How'd the deep hollower go?

A design critique: On the right track but I would like to have seen more curve in the base including on the transitions. And the lower transition I would like to have seen higher.

Hope you don't mind the critique.

Ted looks really nice.........I'll have to take a look at Vern's hollowing set up again.

Ted,
That looks good to me. Pretty good effort saving the bark rim. Did it take some CA there also?
Regards
John.

Thanks for the comments
Brendan ,Is what you are saying is that the shoulder should be higher, because that's what I think?
I find the rig much easier to use than other tools I have used . There is no fighting , you just push the tool in .I am using the rig with a Woodcut Proform flexi Hollower shaft fiitted to cut round the shoulder area then change to a homemade 20mm shaft with a Woodcut Proform power head as I get deeper.
Orraloon, I ran CA around the cambium layer to help hold the bark on.
Ted

Originally Posted by turnerted

Thanks for the comments
Brendan ,Is what you are saying is that the shoulder should be higher, because that's what I think?
I find the rig much easier to use than other tools I have used . There is no fighting , you just push the tool in .I am using the rig with a Woodcut Proform flexi Hollower shaft fiitted to cut round the shoulder area then change to a homemade 20mm shaft with a Woodcut Proform power head as I get deeper.
Orraloon, I ran CA around the cambium layer to help hold the bark on.
Ted

Yep, that's right Ted. Having it as low as you've got it has the visual effect of dragging the design down making it look bottom heavy. Lift that shoulder and put a little more curve in it would improve it considerably.

Hope you have another go at it. And pleased you have taken the critique well.