Results 1 to 6 of 6
Thread: Norfolk Island pine bowl
-
30th November 2019, 10:12 PM #1
Norfolk Island pine bowl
I recently acquired a lump of Norfolk Island pine about 400mm diameter and about 400mm long. I could barely lift the dam thing so I cut it in half, now I have two discs about 400mm diameter and 200mm long. Painted the ends with "Mobilcer M", to minimise splitting while drying further. The first on is in the lathe to rough turn to hasten the drying process.
The block trimmed and ready for the lathe.
NFI Pine BowlS.jpg
Some of the "waste"
NFI Pine Bowl2S.jpgNFI Pine Bowl1S.jpg
The back
NFI Pine Bowl4S.jpg
Wrapped in a damp towel for the night and will be ready to attack the centre tomorrow.
JimSometimes in the daily challenges that life gives us, we miss what is really important...
-
30th November 2019 10:12 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
1st December 2019, 04:40 PM #2GOLD MEMBER
- Join Date
- Jun 2006
- Location
- Burwood NSW
- Age
- 82
- Posts
- 1,247
Jim
Looking forward with interest . The last time I tried one of these all the branch points split . Are you doing anything to minimise this ?
Ted
-
1st December 2019, 06:01 PM #3
Jim when I did the vase some yrs back at the club, Darrell had me soak the wood with a soapy solution 5% soap to water as it was a week between turning sessions a hessian sack and damp cloths. That stopped the drying out also sprayed inside.
When I got the lathe and vessels home, as I got thinner walls a spray bottle of Hard Burnish Oil was used, this firms it up also cut down on tear out
My 2nd attempt much better some time latter
Looking forward to seeing what comes of your two.
-
1st December 2019, 08:43 PM #4
Hi Ted,
This is the first time I have used Norfolk pine in this way, that is straight down the end grain. To minimise cracking I kept the turned job in a moist towel. Just came up from the shed with the finished bowl. Tomorrow, I think I will coat it with a wax. No, I haven't done anything special to prevent problems other than to keep it moist.
JimSometimes in the daily challenges that life gives us, we miss what is really important...
-
2nd December 2019, 02:51 AM #5Member
- Join Date
- Sep 2008
- Location
- Richards Bay
- Age
- 74
- Posts
- 78
Use a thin superglue on the ends of the branches. They will crack no matter what but CA usually stops it going further. Also once finished turning and sanding apply CA again
-
5th December 2019, 10:05 PM #6SENIOR MEMBER
- Join Date
- Aug 2017
- Location
- Canberra
- Posts
- 587
Norfolk Pine is spectacular wood, looking forward to seeing the result
Similar Threads
-
Norfolk Island Pine
By Oldgreybeard in forum WOODTURNING - GENERALReplies: 18Last Post: 26th November 2015, 11:02 AM -
Norfolk Island Pine
By comgreserv in forum TIMBERReplies: 9Last Post: 25th January 2014, 10:35 AM -
Norfolk Island pine...?
By reeves in forum TIMBER SWAPReplies: 26Last Post: 6th May 2009, 10:41 PM -
Norfolk Island Pine
By Kev Y. in forum WOODTURNING - GENERALReplies: 2Last Post: 30th August 2002, 04:19 PM