Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 17 of 17
-
11th November 2019, 04:25 AM #16GOLD MEMBER
- Join Date
- Sep 2008
- Location
- North Carolina, USA
- Posts
- 2,327
I made a 6 inch round of hardwood to fit in the chuck with a flat face which has foam tape holding a piece of 36m grit sand paper. I use it to jam roughly flat pieces against with the tail center to flatten or make a spigot to grab in the chuck. I also have made a variety of the above chuckable drive centers. I see above that many minds run in the same ditch.
So much timber, so little time.
Paul
-
11th November 2019 04:25 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
11th November 2019, 09:44 AM #17
Similar Threads
-
Scroll Chuck Drive centre
By pkroeze in forum WOODTURNING - GENERALReplies: 12Last Post: 16th April 2018, 09:08 PM -
Dynalink spur drive centre
By powderpost in forum WOODTURNING - GENERALReplies: 4Last Post: 27th May 2015, 09:49 AM -
Weak drive centre
By Tiger in forum WOODTURNING - GENERALReplies: 47Last Post: 24th March 2009, 12:18 PM -
Drive centre for vertical lathe
By jmk89 in forum WOODTURNING - GENERALReplies: 8Last Post: 5th July 2008, 09:00 AM