Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 17 of 17
-
11th August 2012, 09:20 AM #16
Retired
- Join Date
- May 1999
- Location
- Tooradin,Victoria,Australia
- Age
- 73
- Posts
- 11,918
I will second that.
Originally Posted by KBs PensNmore
Mark, it might be an idea to visit Northern Turners, just to see what it is all about, as I found that I picked up a LOT of bad habits "teaching myself".
I visited the local turning club where I was shown a lot of different techniques and consequently I joined. Reading all the books in the world and asking all the questions is no substitute for being taught and shown basics on how to do something correctly.
They meet at the Golden Grove High School, Technical Centre between 10am to 3pm on the 3rd and 4th Saturday of each month.
Kryn
-
11th August 2012 09:20 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
11th August 2012, 01:33 PM #17
Lignum Vexator
- Join Date
- May 2007
- Location
- North of the coathanger, Sydney
- Age
- 68
- Posts
- 9,417
When are you next in Sydney? Doubt I'll be down your way anytime soon Originally Posted by
...
If I could find a cameraman with a camera I would do video. Any takers?
regards
Nick
veni, vidi, tornavi
Without wood it's just ...
Reply With Quote
Similar Threads
-
how would I carve a curved hole into a curved piece of wood?
By ane in forum WOODWORK - GENERALReplies: 1Last Post: 22nd February 2010, 07:30 PM -
L7 Mig PRACTICAL
By Grahame Collins in forum WELDINGReplies: 0Last Post: 8th June 2009, 06:56 PM -
Advice on sourcing 1" unhandled skew?
By Skew ChiDAMN!! in forum WOODTURNING - GENERALReplies: 48Last Post: 28th September 2007, 07:37 AM -
Advice needed for cutting a shallow rebate for inlay banding on a curved apron
By Rocker in forum WOODWORK - GENERALReplies: 19Last Post: 5th December 2005, 12:11 AM
