Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 21 of 21
Thread: Spindle thread cover/protector
-
14th January 2014, 08:56 PM #16Senior Member
- Join Date
- Dec 2008
- Location
- 75 km north of newcastle
- Age
- 76
- Posts
- 110
Are we talking about the outboard spindle thread? If so, it is left hand thread. I don't think taps & dies for L/H thread are all that easily found.
Mickcmañana
-
14th January 2014 08:56 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
15th January 2014, 01:32 AM #17
The Thread.
Hi Jim,
Had my Lathe since 1990, has done quite a lot of work, & the thread is as clean as a whistle.
I'd just say, be a little bit careful, but if you need one, then as was said, make a wooden one.Regards,
issatree.
Have Lathe, Wood Travel.
-
15th January 2014, 11:39 AM #18Jim
- Join Date
- Feb 2008
- Location
- Victoria
- Posts
- 3,191
-
15th January 2014, 11:42 AM #19Jim
- Join Date
- Feb 2008
- Location
- Victoria
- Posts
- 3,191
-
15th January 2014, 01:20 PM #20Senior Member
- Join Date
- Aug 2010
- Location
- Wattle Glen Vic
- Posts
- 116
That is because the head stock is not hollow all the way and you cannot use a knock out bar to remove any device you put in the morse tapper.the record and the coronet came out with a threaded ring you screw on the spindle before putting anything in the morse tapper and when you need to remove the device from the tapper you just unscrew the threaded ring and it forces out anything in the tapper.
-
15th January 2014, 02:09 PM #21Jim
- Join Date
- Feb 2008
- Location
- Victoria
- Posts
- 3,191
Similar Threads
-
Tapered spindle thread
By morrisman in forum METALWORK FORUMReplies: 8Last Post: 17th December 2011, 04:35 PM -
ATM260 Spindle Thread
By dle147 in forum THE HERCUS AREAReplies: 13Last Post: 16th November 2011, 10:02 PM -
Worn thread on a saw spindle
By Ray153 in forum METALWORK FORUMReplies: 21Last Post: 30th June 2009, 07:22 PM -
Jet spindle thread
By rodjocumsen in forum WOODTURNING - GENERALReplies: 7Last Post: 28th July 2006, 09:25 AM -
Spindle Thread
By antman in forum WOODTURNING - GENERALReplies: 2Last Post: 20th September 2003, 04:45 PM