Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: thin spins
-
16th August 2013, 01:20 AM #1Senior Member
- Join Date
- Jul 2012
- Location
- Minnesota USA
- Age
- 64
- Posts
- 150
thin spins
A while back someone asked about getting some turnings done. They were thin, one end 9/16" the other 1/2" and a 3/8" section extending out of the smaller end for 1 1/4". overall length was 12". I had recently moved my equipment into a new shop and decided to overhaul the lathe. This would include an increase in diameter from 10" to 12" throw and a vfd. since I was changing the diameter there were changes that had to be made elsewhere. the lathe is capable of single pass but since the diameter changed i would need to change some things there as well. I ended up setting up in the DIY lathe. I tried several tool grinds and approaches. no mater how skimpy I left the last cut it would chatter. Finally I decided to make a router mount for the lathe and try that.
here are a couple vids of the result
gch 001 - YouTube
a different angle
gch 002 - YouTube
the time was well spent 100 parts from board to finish in less than three hours including set up!
-
16th August 2013 01:20 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
16th August 2013, 09:19 AM #2
Functions well but might be a good idea to turn the router off while sanding - just in case.
Similar Threads
-
Very thin ply
By wombatie in forum SCROLLERS FORUMReplies: 8Last Post: 20th August 2010, 04:23 PM -
elu 96e spins backwards
By davev8 in forum HAND TOOLS - POWEREDReplies: 2Last Post: 11th June 2010, 03:08 PM -
thick or thin ca
By mkypenturner in forum WOODTURNING - PEN TURNINGReplies: 6Last Post: 6th April 2009, 09:04 PM -
Where to buy thin cut Oak?
By AntonyG in forum TIMBERReplies: 1Last Post: 23rd October 2006, 10:44 PM -
Is it true that water down the drain spins the other way down here?
By Original-Bart in forum WOODWORK - GENERALReplies: 35Last Post: 7th April 2005, 03:45 PM