![Thanks](https://www.woodworkforums.com/dbtech/thanks/images/thanks.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 11 of 11
Thread: New Top
-
13th May 2013, 04:11 AM #1
Novice
- Join Date
- Feb 2013
- Location
- Texas
- Posts
- 10
New Top
New top of Silmar 41 resin, aluminum,& brass turned on the Vicmarc and embellished on my rosé engine.
-
13th May 2013 04:11 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
13th May 2013, 06:37 AM #2
Senior Member
- Join Date
- Jul 2012
- Location
- Minnesota USA
- Age
- 64
- Posts
- 150
do you have to degas that to get a perfect clear finish on that or do the bubbles clear out naturaly before it sets?
Roger
-
13th May 2013, 06:50 AM #3
Novice
- Join Date
- Feb 2013
- Location
- Texas
- Posts
- 10
I cast it in a paint pot under 60 psi. Here is a picture of the billet which I slice in half to make two disc. My mould also. 4" diameter.
-
13th May 2013, 08:06 AM #4
Senior Member
- Join Date
- Dec 2008
- Location
- Clarence Town
- Age
- 70
- Posts
- 217
Hi,
I must confess that in years gone by I was not a fan of ornamental turning - maybe it was fear of the unknown. However, my opinion has gradually changed to the point that I am now in awe of much of this work.
As to your effort - simply beautiful
What more can I say?
-
13th May 2013, 09:17 AM #5
Excellent piece
The humble spinning top has risen to a level elegance with this oneI can see at this rate you're probably going to attract collectors.
Well done, a magnificent spinning top.
reminds of the 'gasing' tops of Malaysia. Spinning The Gasing | Malaysians in New ZealandInspiration exists, but it has to find you working. — Pablo Picasso
-
13th May 2013, 01:49 PM #6
-
13th May 2013, 01:51 PM #7
Welcome to the forum
What an impressive piece.
Is your Rose Engine home made or commercially bought??
-
13th May 2013, 03:11 PM #8
Novice
- Join Date
- Feb 2013
- Location
- Texas
- Posts
- 10
Home made, I have several cutting devices I'm experimenting with. It's a work in progress.
-
13th May 2013, 04:51 PM #9
New Top
That is fantastic
A spinning top I which I was young again
But then who cares if I had that now
I would be spinning it all over the kitchen floor
-
14th May 2013, 09:19 AM #10
-
14th May 2013, 10:00 AM #11