Needs Pictures: 0
Picture(s) thanks: 0
Results 31 to 31 of 31
Thread: Wood and Metal Turning Job
-
19th December 2014, 07:02 AM #31
Thanks
Joint is push fit but I used epoxy had considered either a brass through pin or screw as well but as the glue joint at this stage is solid either can still be done at a latter date.
I had also considered a threaded joint between wood and brass but not enough material length/depth along the shaft without damaging the map.
-
19th December 2014 07:02 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
Similar Threads
-
Question about metal lathe pen turning
By Jack.Tar in forum WOODTURNING - PEN TURNINGReplies: 10Last Post: 6th April 2012, 03:28 PM -
Metal Inlay Into Wood - Resin/Epoxy with metal powder?
By r5e in forum WOODWORK - GENERALReplies: 14Last Post: 15th March 2010, 11:17 AM -
Metal Turning Projects Book
By YarrD in forum METALWORK FORUMReplies: 6Last Post: 3rd May 2009, 09:33 AM -
Some basic metal turning questions
By Rossluck in forum METALWORK FORUMReplies: 12Last Post: 11th March 2009, 03:12 AM -
Small metal lathes for pen turning
By Big Shed in forum WOODTURNING - PEN TURNINGReplies: 21Last Post: 4th March 2008, 10:02 PM