Picture(s) thanks: 0
Results 16 to 17 of 17
-
12th August 2019, 04:54 PM #16Novice
- Join Date
- Jun 2017
- Location
- Keysborough
- Age
- 74
- Posts
- 16
Thats a great idea about spinning the banjo around, ill keep that in mind. For the Sphere Jig I ended up mounting to the bed by doing the following:
20190812_154311.jpg
Its pretty dodgy but its stable, strong and gets the job done.
Cheers.
-
12th August 2019 04:54 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
11th April 2020, 12:35 PM #17
You could use magnetic base dial indictor and run from spindle to end of table travel
Most accurate and measurable way I know is to use magnetic base dial indicator, set-up at spindle and run to the end of table travel to check for twist, taper and/or misalignment, then use spirit level to guide and adjust until indicator readout is within acceptable criteria and tolerances...
Similar Threads
-
Woodfast C1000 lathe and chisels for sale $1000
By MadMatt33 in forum Chisels-handmadeReplies: 3Last Post: 11th April 2020, 12:48 PM -
VICTORIA Woodfast C1000 lathe and chisels for sale $1000
By MadMatt33 in forum WOODWORK - Tools & MachineryReplies: 1Last Post: 27th June 2019, 06:03 PM -
Woodfast C1000 Series 2 Lathe for sale
By Xanthorrhoeas in forum WOODWORK - Tools & MachineryReplies: 4Last Post: 4th May 2017, 12:24 PM -
Woodfast C1000 Series 2 Not an Auction
By Xanthorrhoeas in forum WOODWORK - Tools & MachineryReplies: 3Last Post: 2nd April 2017, 06:48 PM -
retro fitting evs to woodfast c1000
By John T in forum WOODTURNING - GENERALReplies: 3Last Post: 9th November 2015, 08:53 PM