Thanks Thanks:  0
Likes Likes:  0
Needs Pictures Needs Pictures:  0
Picture(s) thanks Picture(s) thanks:  0
Results 1 to 3 of 3
  1. #1
    Join Date
    Apr 2006
    Location
    australia
    Posts
    1

    Default Roller door tension adjustment

    Hello,

    Tried installing my owner remote control for the roller garage door and have resulted in the springs letting go and now the door is closed.:confused: The springs are all loose and I can't roll the door back up manually. I know I have to tighten up the tension again. My question is I have very limited space on either side to use a pipe wrencd, just wondering can i tighten the tension via the axle in the middle ? can the tension be tighten while the roller door is closed

    Any suggestions will be much appreciated

    billy

  2. # ADS
    Google Adsense Advertisement
    Join Date
    Always
    Location
    Advertising world
    Posts
    Many





     
  3. #2
    Join Date
    Oct 2003
    Location
    Kentucky NSW near Tamworth, Australia
    Age
    84
    Posts
    3,746

    Default

    Hi Billy

    I posted the following before if you have a look and see if it will help you.

    http://www.woodworkforums.ubeaut.com...ht=Roller+door


    If not the other alternative is to take the door down with which you will need help and roll the door up and start from scratch.

  4. #3
    Join Date
    Apr 2006
    Location
    NSW
    Posts
    157

    Default

    All I do is raise the roller door then wrap a strong strap or good rope, round and over the door pulled/tide nice and tight. Bend the tabs on top of each rail so the door can be lifted out of the rails and turned/tensioned, From memory approx 1 1/4-1 1/2 full turns(new door). then slide it back in the rails and your done( after bending the rail tabs back)remove rope and it's done.

    ps Installed many a roller door with bars/tools etc before I realised just how silly it was

    HJ0

Similar Threads

  1. Height adjustment wheel on triton router
    By EMistral in forum ROUTING FORUM
    Replies: 8
    Last Post: 21st December 2005, 08:51 PM
  2. Unhappy with Triton router height adjustment
    By Hennie in forum TRITON / GMC
    Replies: 73
    Last Post: 3rd July 2005, 09:35 AM
  3. Roller door tension
    By rev in forum THE GARDEN SHED
    Replies: 13
    Last Post: 3rd May 2005, 10:36 PM
  4. Sturdee Laminate/veneer Roller.
    By Sturdee in forum HOMEMADE TOOLS AND JIGS ETC.
    Replies: 2
    Last Post: 20th July 2004, 09:18 PM
  5. Table saw adjustment.
    By Robert WA in forum TABLE SAWS & COMBINATIONS
    Replies: 1
    Last Post: 10th August 2003, 11:22 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •