Thread: Installing Flushbolts in French Doors

If there is no falnge I guess you have to very carfully use a router. Actually a quick search on Google found a website brand of flsuh bolts that sid they also offered a router bit to aid installation (http://www.spec-net.com.au/press/1104/henderson.htm).

This brand has a round top so I'd guess that you get the right size router bit to fit the round end and do one stright run out to the edge of the door.

Bob,

Thanks mate, "very carefully" seems to be the order of the day. Only thing is the flush bolts I've found dont have that nice rounded end......


Andrew

Quite possibly someone out there has a better idea?

But for a square end I'd still go a router but use a smaller bit, then you will be left with two small radius corners at the en that you can take out with a sarp chisel.

You want a good router bit and a good sharp chisel. Since you only get one shot I'd also clamp a guide to your door to run your router along so it doesn't drift.

You could also just do it with a chisel depending who steady your hand is???

Why not make a template and use a template guide on the router.

some flush bolts can be set up in the edge of the door. tghis depends on the width of the rebate. It means you dont have to be quite as neat and is better from a secuity point of view. Normally I put them in With A chisel because there is so many different depths required.