Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Shaker style drawer fronts
-
2nd April 2021, 08:54 PM #1Member
- Join Date
- Dec 2010
- Location
- Morayfield, Queensland
- Posts
- 51
Shaker style drawer fronts
I'm looking at replacing our flat vinyl coated kitchen drawer fronts with white shaker fronts. From searches I've done on here I gather the best material for rails & styles is 18mm MR MDF, not sure what thickness the centre panel MDF is though. Next issue is the paint. I didn't want a gloss finish but the more traditional satin or flat white finish. Has anyone made these and what material / paint would you recommend ?
-
2nd April 2021 08:54 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
31st May 2021, 02:00 AM #2
If you are still interested in a reply, how are you planning on making these? There are shaker style cope & stick router bit sets that typically take a 6mm panel. MDF gets furry on the cut edges, so a pre-prime step is required at least once for a good finish. I use Zinsser B-I-N, which is a white tinted shellac. (Its $95 for 4 litres, but you can’t make your own shellac for that).
Two-pack paints are what is considered high end here, but that requires serious spray and safety equipment. Dulux had a renovation range that is water based with a hardener. Haven’t tried it, but I would like to, at least as an experiment. The range includes a satin clear coat.
Really really high end finishing in the UK market is done by brush on traditional cabinet designs.It's all part of the service here at The House of Pain™
-
31st May 2021, 09:16 AM #3Member
- Join Date
- Dec 2010
- Location
- Morayfield, Queensland
- Posts
- 51
Hi Greg,
I have the cope & style router bits you described but undecided on what timber to use for the best paint finish.
-
31st May 2021, 09:55 AM #4
I have a friend who works in an ultra high end cabinet shop. Oddly, they use melamine covered MDF and then paint over it. There are (apparently) primers that will cover the melamine.
I have made panelled doors out of hoop pine before...wouldn’t do that again. Any wood is going to move seasonally which will degrade the finish. At least with MDF you can glue the panels in place too.
The pre-prime prep work takes at least as long as the construction. We have lots of panelled features in our new house and I think, conservatively, that we have done over 300 hours of soul-destroying prep work.It's all part of the service here at The House of Pain™
Similar Threads
-
Spacing Drawer Fronts
By Sir Stinkalot in forum FURNITURE, JOINERY, CABINETMAKING - formerly BIG STUFFReplies: 3Last Post: 15th December 2018, 02:47 PM -
Screws for drawer fronts
By Marwood in forum WOODWORK - GENERALReplies: 9Last Post: 11th December 2014, 10:50 AM -
Laminated and raised drawer fronts
By John Samuel in forum FURNITURE, JOINERY, CABINETMAKING - formerly BIG STUFFReplies: 0Last Post: 28th March 2014, 02:17 PM -
Domino for drawer fronts
By Redgy in forum FESTOOL FORUMReplies: 1Last Post: 24th November 2008, 11:17 PM -
Installing new drawer fronts.
By eemgee in forum KITCHENSReplies: 2Last Post: 11th September 2006, 02:38 PM