Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
30th March 2013, 11:00 PM #1
timber shelf - how much support needed?
I'm putting a shelf in the study above the desk. Plan is for the shelf to go from wall to wall, so it will be 3.5m wide (long?), 300mm deep.
Question is: will it be enough to support the shelf on 3 sides (along the back, and 300mm on each side wall)? Do I need something in the middle? If so, what? Will the ends be strong enough if they're just sitting on some supports.
I was planning to use some architrave timber (16mm deep?) to match the doorways as the supports and will be screwing the whole lot into studs. I've had an extra stud added in each side wall (200mm from the corner) when the room was built so the side supports will go into studs.
Shelf will hold books, and other junk.. heavy-ish I guess, but not overloaded.. Shelf is a solid plank of Jarrah (heavy!)
See attached plan.
Thanks !
Attached Thumbnails
Read the full thread at RenovateForum.com...
-
30th March 2013 11:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
DXF support needed!!
By 1964deano in forum CLOCKSReplies: 12Last Post: 11th April 2013, 07:42 PM -
shelf support
By new growth in forum WOODWORK - GENERALReplies: 4Last Post: 6th April 2009, 08:02 PM -
Shelf support brackets-which way
By Strungout in forum WOODWORK - GENERALReplies: 3Last Post: 8th February 2008, 09:12 PM -
Tech Support Needed
By fred.n in forum WOODIES JOKESReplies: 2Last Post: 28th September 2006, 11:08 PM