Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: How are these box corners made ?
-
25th October 2013, 09:56 AM #1GOLD MEMBER
- Join Date
- Mar 2008
- Location
- Townsville, Nth Qld
- Posts
- 4,236
How are these box corners made ?
I have for a long time been fascinated by the design in the picture below, with the box corners made of another contrasting timber. I have recently seen one at one of the wood galleries in Leura NSW while on holidays in the Blue Mountains, and would now like to have a go at it, if it is not too difficult.
Can anyone please advise how the 10 x 10mm, say, corner timbers are attached to the sides? When the lid was opened, there was no evidence of a spline where the lid had been cut away from the box.
contrast corner box.jpgregards,
Dengy
-
25th October 2013 09:56 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
25th October 2013, 11:32 AM #2Skwair2rownd
- Join Date
- Nov 2007
- Location
- Dundowran Beach
- Age
- 76
- Posts
- 19,922
They may well just be Dowelled/pinned and glued.
-
25th October 2013, 12:17 PM #3
Or mortise & tenoned, stopped short of the edges. The same could be done with splines.
I made a similar box with M&T's some time back (although it also had top & bottom rails so I could inset the main panels similar to a picture frame) and found that at small sizes (eg. <10x10mm corners) accuracy is fairly critical to maintain a strong joint BUT there's so little timber to work with that - apart from initial sizing - hand tools become far more useful than power tools.
- Andy Mc
-
28th October 2013, 02:07 PM #4Senior Member
- Join Date
- Nov 2012
- Location
- Sydney
- Posts
- 266
I have an identical box made by Peter Gorring using Tiger Mrytle top, Celery Top Pine sides, Blackwood stringing and the Silky Oak corners..it's beautiful...
Why don't you try and contact Peter directly?
Regards,
John
Similar Threads
-
Help in Corners Square
By Richo in forum BOX MAKINGReplies: 15Last Post: 30th July 2012, 07:35 PM -
can't cut corners with the Domi XL
By John Saxton in forum FESTOOL FORUMReplies: 0Last Post: 20th January 2012, 11:33 PM -
Radius Corners
By Knocker in forum METALWORK FORUMReplies: 2Last Post: 26th November 2007, 12:45 AM -
joining corners
By Tonyz in forum WOODWORK - GENERALReplies: 8Last Post: 23rd July 2007, 10:46 AM -
How do you get in the corners
By rat52 in forum FINISHINGReplies: 1Last Post: 29th March 2007, 09:09 PM