Thread: Two Jewelry Boxes

Originally Posted by masoth

I agree with the accolades above - I'd love to do work like that.
Just for interest would you mind listing the tools you used to make the boxes, please?

soth

Here it goes...

Jointer - (edge the rough wood)
Bandsaw - (resaw, drawer pulls)
Planer
Table Saw (my new SawStop )
Table Saw ( my old General with my Smart Miter jig setup)
Router Table with Incra Fence System
Drill Press (drilling and drum sanding attachments)
Drum Sander

And plenty of gidgets, gadgets, jigs, whirly gigs, scary sharp chisels, fixtures, specialty TS blades and not to leave out, a vocabulary that I wanted to yell out more times than I could count.

Here's the place where it all happened. http://www.woodworkforums.ubeaut.com...ad.php?t=42920

About the only tool I didn't use on this project was my little red scroll saw.

And here's the 1st box I made as a gift. This shows most of the Work In Process (leaving out some tedious steps though) All in All 60+ hours and 200 Steps.

http://www.woodworkforums.ubeaut.com...ad.php?t=41584

awesome fantastic attention to detail great finish too