Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: wood twist
-
5th July 2008, 09:03 AM #1
wood twist
I just got done sizing a piece of mahogany for a non-box project (remote control caddy). I have had this piece in my house for +/- 2 months, 5-6 weeks of which were in my workroom. The original dimensions were 124cmL, 43cmW, 25mmT, rough cut. I cut off a 81cm long piece, trimmed it down to 24cm wide, then planed it down to 19mm, taking a roughly equal amount of wood from both sides. When it was all done, I set it down on my workbench to draw out the cutting plan, but it had already twisted. No exaggeration, the opposite corners were about 15mm off of the bench.
1) Did it twist because of the machining? If so, where should I have stopped to let it acclimate again?
2) Once it re-acclimates, will it un-twist?
-
5th July 2008 09:03 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
6th July 2008, 03:14 PM #2Intermediate Member
- Join Date
- Sep 2007
- Location
- melbourne
- Posts
- 35
i've had this problem with switenia mahogany recently boards were dressed dead straight but after breaking the boards down into smaller peices (it was for a box so lots and lots of small peices) almost every peice warped and bowed. its been almost half a year and those pieces are still like that
-
6th July 2008, 03:18 PM #3
avengers63,
my deepest simpathy, but it sounds like the timber may have been still green
don't think it will come back. but hey, the bright side. there might be a model aircraft maker in this forum that could use a propeller.lifes to short, learn from other peoples mistakes.
Similar Threads
-
Twist pen wood grain alignment
By dhurrang in forum WOODTURNING - PEN TURNINGReplies: 11Last Post: 6th June 2008, 02:46 AM -
a carveing with a twist
By SPIRIT in forum WOODCARVING AND SCULPTUREReplies: 2Last Post: 13th January 2008, 09:34 PM -
Barley Twist
By mick61 in forum WOODTURNING - GENERALReplies: 13Last Post: 11th September 2007, 06:50 AM -
A new twist on a slimline
By macca2 in forum WOODTURNING - PEN TURNINGReplies: 5Last Post: 18th July 2007, 11:56 AM -
Cyclones....a Different Twist
By Termite in forum DUST EXTRACTIONReplies: 9Last Post: 20th October 2003, 01:41 PM