Thread: Kreg lifter + 2400W INPUT/1800W OUTPUT POWER ROUTER UNIT

I’ve built a router table using this lift kit as well, in my eyes was identical to the other units incra make etc but half the cost.

What router body are you using in it? I put the AUK variable speed body in. Great unit

Cheers
Nathan

Originally Posted by delbs

I’ve built a router table using this lift kit as well, in my eyes was identical to the other units incra make etc but half the cost.

What router body are you using in it? I put the AUK variable speed body in. Great unit

Cheers
Nathan

Never had a dedicated table router before so was cooking my self for it for quite sometimes. End up getting
generic Carbatec from totaltools.

• BRAND: Carbatec Motor: 2400W (3-1/4HP) input / 1800W (2-1/2HP) output - Universal
• Diameter: 106.7mm (~4-13/64")
• Collet Sizes: Included 1/4" and 1/2"
• Variable Speed: Yes 10,000 - 22,000 RPM

Building a table right now.

Originally Posted by delbs

I’ve built a router table using this lift kit as well, in my eyes was identical to the other units incra make etc but half the cost.

What router body are you using in it? I put the AUK variable speed body in. Great unit

Cheers
Nathan

Just tested.
Works very well and promising for more
20230523_114318.jpg

Nice one good to hear

I’ve moved my routing setup over to my combination machine. Working well so far

Think I’ll sell my standalone router table soon

Cheers
Nathan

Originally Posted by delbs

Nice one good to hear

I’ve moved my routing setup over to my combination machine. Working well so far

Think I’ll sell my standalone router table soon

Cheers
Nathan

Yeah, I got the problem to solve now.
My table is a square 1m 20 wide and long. Build in mind to process long and wide pieces.
Cannot find a wood material for router fence that long which will remain un bent and untwisted due to weather. So far the only option is to downgrade to smaller table which will defeat the purpose of dedicated table router.. Or looking at your setup looks like an answer.

Thank You for sharing

This is just a new kreg router too I haven’t modified it, I’ll be installing the incra clean sweep soon and then consider listing it forsale

Cheers
Nathan

Originally Posted by AlexOsk

Yeah, I got the problem to solve now.
My table is a square 1m 20 wide and long. Build in mind to process long and wide pieces.
Cannot find a wood material for router fence that long which will remain un bent and untwisted due to weather. So far the only option is to downgrade to smaller table which will defeat the purpose of dedicated table router.. Or looking at your setup looks like an answer.

Thank You for sharing

Why not use aluminium extrusion for the fence?