Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Mini Table Saw Insert
-
10th July 2019, 08:59 AM #1New Member
- Join Date
- May 2012
- Location
- Canada
- Posts
- 8
Mini Table Saw Insert
The attached indicates the rough cut out for my insert (blade is 5.5” OD). In the opening shown I want to make a lip all around about 1/4” wide by 1/8” deep for my insert to sit snug. All corners will be rounded
I think I have to make a template for my router to ride along and cut the lip + to make the insert itself afterwards. Is there a way to make this work without a template which is time consuming?
I have a set of bushings from 1” all the way down to 5/16” and I only have a big 10 Amp router. Ideal would have been a palm router which I don’t have.
Thanks
-
10th July 2019 08:59 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
10th July 2019, 10:02 PM #2
Could you not just use a rabbeting bit with a bearing?
-
11th July 2019, 01:34 AM #3New Member
- Join Date
- May 2012
- Location
- Canada
- Posts
- 8
Similar Threads
-
N.S.W. Router Table Insert
By pach in forum WOODWORK - Tools & MachineryReplies: 3Last Post: 5th May 2018, 08:26 AM -
Jigsaw table insert
By Kuffy in forum HAND TOOLS - POWEREDReplies: 4Last Post: 18th July 2016, 06:35 PM -
Bandsaw Table Insert
By Woodlee in forum METALWORK FORUMReplies: 10Last Post: 28th July 2008, 10:20 PM -
Insert position in table top
By greenie512 in forum ROUTING FORUMReplies: 2Last Post: 22nd July 2007, 10:11 AM -
Router table insert
By finnster in forum ROUTING FORUMReplies: 5Last Post: 29th November 2002, 02:32 AM