Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Colour Correction
-
16th August 2010, 10:42 AM #1Enthusiatic Amateur
- Join Date
- Jun 2007
- Location
- Toowoomba
- Posts
- 144
Colour Correction
I've recently completed making a fairly large tool cabinet using the timber from the pallets on which my machinery was delivered about two years ago. The timber had weathered considerably but responded well to the planer. It is European in origin, pine of sorts and very pale - almost white.
The cabinet is meant to look rather rustic but because the timber is so porous, I thought I would seal the outside with shellac. BIG mistake. Dirty yellow, I think describes it.
No worries, I thought, a couple of coats of turps-based baltic stain in Feast & Watson Polyurethane should do the trick. Well, it hasn't! Marginally better, but still ugly.
So, what to do?
- Use a stronger baltic/poly mix over the top?
- I want to keep the grain (for what its worth) appearance (see 'rustic' above), so painting is not really an option
- Never use shellac on pale-coloured timber again
- Sanding back to raw timber is not really an option
Cheers
Brian
-
16th August 2010 10:42 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
16th August 2010, 11:56 PM #2Intermediate Member
- Join Date
- Apr 2010
- Location
- Indonesia
- Posts
- 45
Well it rather difficult situation. It seems the to re sand your old finish is the only option you have.
You may try to do some application on your previous finish, but the result may not satisfy
The yellow color is come from the shellac. If you don't like the yellow you need to uses clear coating such as nc, water based, varnish or polyurethane.
If you like shellac, then you need to use the bleach shellac which has no yellow color.
Good luck
wisnoLast edited by RETIRED; 16th September 2010 at 01:05 PM.
-
17th August 2010, 06:32 PM #3Enthusiatic Amateur
- Join Date
- Jun 2007
- Location
- Toowoomba
- Posts
- 144
Thanks wisno.
I think I've got this sorted. I used some F&W Varnish and Stain. This has dulled considerably the 'tiger' look I had achieved using the shellac and then adding baltic stain to polyurethane. I'll add a second coat tomorrow and hopefully, that will be that.
Similar Threads
-
Correction to MSD Rowboat stem
By Boatmik in forum Michael Storer Wooden Boat PlansReplies: 7Last Post: 19th August 2009, 02:14 PM -
colour
By philzero44 in forum BOAT BUILDING / REPAIRINGReplies: 5Last Post: 18th November 2008, 04:34 PM -
Correction
By Rodgera in forum WOODIES JOKESReplies: 2Last Post: 13th October 2007, 08:34 PM -
Correction - The Triton Woodworker
By DPB in forum TRITON / GMCReplies: 1Last Post: 15th October 2005, 11:48 AM -
Colour
By Shane Watson in forum FINISHINGReplies: 1Last Post: 28th August 2001, 12:37 PM