Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
-
28th July 2011, 03:47 AM #1Novice
- Join Date
- May 2010
- Location
- Brisbane
- Posts
- 13
Finish raw NGR kitchen cabinet doors
Hi -- I'm planning to finish some solid timber kitchen cabinet doors (NG Rosewood) that I've ordered from a cabinetmaker. I've done a bit of reading in this forum, and I just thought I'd ask to see if I'm the right track...
For a sanding sealer, I was thinking of using a thin shellac sealer.
For the finish, I was thinking of using a satin oil-based single pack polyurethane, such as Cabots CFP (actually a floor poly, but at least one forum member likes it for furniture as well).
I don't have spray equipment, so I was planning to use a brush. The self-leveling properties of a floor poly would seem to make this a reasonable way to go.
I was thinking two coats of poly on top of the sanding sealer should about do it (sanding between coats).
Any comments or suggestions on this plan?
Thanks for your advice.
-
28th July 2011 03:47 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
28th July 2011, 06:44 AM #2
Sounds like a plan. I have used the same thing on on kitchen cupboards and a kitchen table.Lasted the distance with the usual abuse from a growing family. At the time I was after something to take the hard knocks and be ok to wipe down. I used a brush also. I would it on a day with good natural daylight to avoid those brush marks you only see after the job is done.
Regards
John
Similar Threads
-
Kitchen cabinet doors
By fatty500 in forum WOODWORK - GENERALReplies: 1Last Post: 9th March 2009, 09:46 PM -
Kitchen Cabinet Doors
By Honest Gaza in forum WOODWORK - GENERALReplies: 7Last Post: 12th August 2003, 12:11 PM