Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
-
14th September 2007, 10:56 AM #1
Matching new oak to old oak in repair.
Here's the problem. I have been doing a repair to an old (50 yrs.), much repaired (badly),clerck's desk that's been in the family. Not particularly valuable, but means a little to some of us. Have had to replace a panel on the top with a 12 in. by 24 in. piece of new red oak and made new legs and skirting. All have been replaced before at least a couple of times. Would like very much to retain the look of the old oak and not have a two toned look. It has always been finished without staining and I would like to return it to as natural a look as possible. I was thinking of a pecan stain with a little walnut stain mixed in for just the new pieces, but am a novice so would appreciate any ideas. Thanks ahead of time.
John"If the doors of perception were cleansed everything would appear to man as it is, infinite."
William Blake
-
14th September 2007 10:56 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
14th September 2007, 06:32 PM #2
try strong tea/coffee or
potassium bichromate solution or
nitric acid
or the special treatment for ageing oak ... ammonia.
do tests
-
14th September 2007, 09:27 PM #3Senior Member
- Join Date
- Feb 2006
- Location
- USA
- Posts
- 402
Finishing
You might want to consider using some of the colored shellacs, there are several different colors to choice from, you could also combine the shellacs and create other colors.
Always, make up complete samples before you work on your project.
Good LuckLast edited by MacS; 14th September 2007 at 09:29 PM. Reason: left out information
-
15th September 2007, 07:13 PM #4
Well, appreciate the ideas. I'll have a go at it today and see what I can do. Will post results later. Thanks for the help.
"If the doors of perception were cleansed everything would appear to man as it is, infinite."
William Blake
Similar Threads
-
American oaks.?
By charlieart66 in forum TIMBERReplies: 3Last Post: 24th July 2007, 12:24 PM -
What timber is this?
By woodbe in forum TIMBERReplies: 14Last Post: 26th December 2006, 05:03 PM -
Repair of Broken Cast Iron
By Grahame Collins in forum METALWORK FORUMReplies: 0Last Post: 11th February 2006, 11:35 PM -
Three problems in one post
By keith53 in forum WOODTURNING - GENERALReplies: 28Last Post: 7th June 2005, 12:48 PM