Microwaving Burr almost turned

**R12chard** · 11th March 2005, 10:06 PM

I'll be finishing turning a burr vase type bowl like the attached but with lots of deep cuts in the side to so that when I nuke it the layers will warp, and hollowed at the same width as the entry. I've had instruction on how to nuke it but was just wondering what to finish it with? Would a soft wax be suitable or just leave it finely sanded?

**Taffy** · 14th March 2005, 10:27 PM

Wax it, if you don't put some sort of sealer on the wood it will warp even more, also which in this case is probably more important, it will change colour over time, as it is hard wood it will darken.
When you "Nuke"it, make sure you weigh it before and during each time you present it to the microwave, Don't make the mistake of cooking it too fast or you will have a large crack appear somewhere.
Good luck.

Taffy

**gatiep** · 14th March 2005, 11:06 PM

Probably nuked to bits by now! Remember to use the defrost setting or you'll end up with a fire brigade call out account!

Whatever you do/did...........hope you enjoy/enjoyed it.

**R12chard** · 16th March 2005, 12:08 AM

Keep your eye on this thread as I'll post pics of the finished article in a couple of days. Did it on defrost, no cracks or burns

)

Thanks for the advice.

Richard

**R12chard** · 19th March 2005, 12:05 AM

The finished article.

Next time I get my hands and chisels on some wet burr I willhave another go I liked the results.

Richard

Thread: Microwaving Burr almost turned

Thread Tools

Search Thread

Microwaving Burr almost turned

Complete

The finished article

Tags for this Thread

Posting Permissions