Thread: Refinishing oregon kitchen

Originally Posted by simopimo

We have an oregon kitchen (benches, benchtops, cabinets, the works) which isn't the best material for a kitchen in my opinion,

We have oregon in our kitchen too and I agree it was a poor decision.

Originally Posted by simopimo

but need some advice as to what's the best finish to use. Intergrain? Cabot's? Feast Watson? Others? Varnish? Poly? Acrylic?

Any advice appreciated!

The first time I used a single pack poly it lasted about 2 years. The second time I used a 2-pack poly and it has lasted about 5 years but now needs redoing.

Cheers

Yeah our current poly was done in 2002 so that's about 4 years, but it's long overdue for re-coating. The black spots appeared along the timber joins and around the sink about 18 months ago, but now the black spots around the sink have become worse...

The carpenter that did the work sanded it back to bare timber and did 2 coats of poly in the one day... which I suspect is part of the issue.

I should have had them laminated or something!!!!


What poly did you use last time BobL?

I'd be surprised if water is penetrating the poly through the horizontal surface. It's more likely entering the end grain, possibly under the edge of the sink.

Might pay to worry less about the type of finish than how you seal the sink edges etc.

Most of our water penetration has been following something dinging the surface, crockery or pot edge or knife etc and very little near sink edges where I really laid it on well around the seams.

I used Cabots CFP with the accelerator - it's really meant for floors and gives a nice hard finish. It's lasted more than twice as long as single pack poly so it was worth it. Watch out for that accelerator I nearly poisoned myself on it because I was stupid and took one of my gloves off to wipe away a few dropped brush hairs and got the stuff on my skin. Fortunately once it dries on the surface its harmless.

mmmm, the material will always haunt you, as evidenced by others. Check out some marine products, pricey but good.

If you sand back you may have to use some type of wood cleaner to get the black stuff out before finishing.

Grain filler might also be appropriate.

let us know how you go.
cheers,
conwood

Thanks for the replies everyone. Does anyone think I can get away with not going back to bare timber, but just roughening the current surface where it's good, but bare timber on the dodgy parts?

Just being lazy... oops I mean time efficient.