Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Thinning lacquer for HVLP
-
21st February 2011, 10:00 PM #1New Member
- Join Date
- Feb 2011
- Location
- NSW
- Posts
- 2
Thinning lacquer for HVLP
Hi, has anyone got experience with clear Duralac lacquers, by Sherwood (with HVLP?). The datasheet says that it doesn't require thinning to use? Perhaps it's true, but does seem unusual?
Also sanding between coats, is there any advantage/disadvantage in doing so?
Thanks
-
21st February 2011 10:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
1st March 2011, 10:31 PM #2Intermediate Member
- Join Date
- Apr 2010
- Location
- Indonesia
- Posts
- 45
If it written it doesn,t need thinning, then you may don,t need to.
You better try to spray it and see the result. If you fell the lacquer is too thick then you can add some lacquer thinner to thin it.
If you have viscometer you can measure the viscosity and check with viscosity that work with your hvlp spray gun.
The hvlp gun is work for low viscosity material.
it work for the viscosity material less then 14 second ( measured with NK 2 cup)
EDIT: Link removed by moderator.
thanks
wisnoLast edited by Moderator; 26th August 2011 at 09:48 PM.
-
2nd March 2011, 07:20 AM #3Member
- Join Date
- Apr 2008
- Location
- Currumbin Valley, Qld
- Posts
- 89
Thinning Laquer
I have used Durasilk and found it to be excellent. I thinned the sealer (Sovereign Sealer) and the Durasilk by 10% and seemed to work well.
Cheers, David
-
2nd March 2011, 03:05 PM #4
Everything I've put through my Wagner HVLP set up, has gone on better after thinning
-
27th April 2011, 03:51 AM #5New Member
- Join Date
- Feb 2011
- Location
- NSW
- Posts
- 2
Thanks all for info, got side tracked so a late reply.
I tried without thinning and it was too thick, so in the end thinned down to about 10-15% and it coated pretty well.
Cheers
Similar Threads
-
Thinning aquadhere
By Dills58 in forum GLUEReplies: 2Last Post: 28th December 2010, 11:53 AM -
Thinning with TPDRA
By Arron in forum BOAT BUILDING / REPAIRINGReplies: 20Last Post: 23rd May 2009, 07:08 PM -
Thinning Araldite
By Grumpy John in forum WOODTURNING - GENERALReplies: 19Last Post: 24th November 2008, 12:22 PM -
Thinning for air brush
By keith53 in forum FINISHINGReplies: 2Last Post: 28th October 2005, 08:09 AM -
Thinning Shellac
By peter in forum WOODWORK - GENERALReplies: 1Last Post: 26th September 2002, 10:22 PM