Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
-
2nd December 2012, 11:24 AM #1
Ubeaut Sanding Sealer under Wattyl Stylwood (NCL)
Hello,
Finishing is not my strong point so after reading the ubeaut data sheet I am not clearer.
Basically I want to spray Wattyl Stylwood (nitro cellulose lacquer) as a finish. I believe the timber would benefit from a sanding sealer and the only one I have is the ubeaut sanding sealer.
Does anyone know if I can use this sealer under StylwoodRegards,
G.O.Varvey
-
2nd December 2012 11:24 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
2nd December 2012, 03:59 PM #2
You can use it under pretty much anything.....
- One coat wiped on with a rag and left for a few hours (preferably over night) to dry.
- When dry sand very lightly with 800 or 1200 grit abrasive, just enough to get rid of the nibs of torn grain raised up by the sanding sealer.
That's just about the whole story in a nutshell. You can now finish the surface with whatever you like. You can even get a water dye to soak into the grain after using it.
Hope this helps.
Cheers - Neil
-
2nd December 2012, 04:20 PM #3
Thanks Neil.
Normally I just spray a light coat of lacquer sand and then top coats.
-
2nd December 2012, 05:07 PM #4
Thanks Neil.
Regards,
G.O.Varvey
Similar Threads
-
Thinning wattyl Stylwood
By Arron in forum FINISHINGReplies: 6Last Post: 16th April 2012, 07:09 PM -
ubeaut traditional wax over wattyl stain?
By metalnwood in forum FINISHINGReplies: 2Last Post: 18th October 2011, 11:47 AM -
Ubeaut Sanding Sealer vs Stewmac sanding sealer
By gbx78 in forum MUSICAL INSTRUMENTSReplies: 20Last Post: 19th August 2008, 02:57 PM -
Sanding Sealer or Grain Sealer
By Strungout in forum FINISHINGReplies: 3Last Post: 4th October 2004, 12:03 PM -
Sanding Sealer
By Steve Walkom in forum WOODTURNING - GENERALReplies: 11Last Post: 7th October 2000, 06:48 PM