I have just acquired a 1953 RS lathe. Was difficult to move but managed and it it is place.
I have swapped out the 1ph motor to a 3ph motor with variable speed control.
Should have been running today but was supplied the wrong inverter so have to wait until next week to get the replacement.
Questions:
Is there a source for a 1 3/8 x 6 tap to suit the headstock spindle ?
Is the only difference between the 6", 8" and 10" the length of the leg ?
If so is it possible to shorten the leg on a 6" to make it a 8" ?
Thanks
Phil