Hi to you all,
Well, My Bandsaw Blade appeared to be a little bit on the blunt side.
So I thought I wood give it a bit of a Sharpen.
At the Last Melb.W w Show, I bought a 10 Pack of Diamond Impregnated Wheels / Discs for my Moto Tool, Dremel Type. $10.
I Should have measured them, but they are approx. 20mm.x ½mm.?
So I marked the Blade, had a light out to the L H Side, which lit up the Teeth really well.
I used a Double Lens Magnifier too. Far better to see with.
Put the Stop Watch on & 19Mins. later I had the 2375mm. x 6 TPI. blade done, & approx. 396 Teeth. & about 20 Teeth a Min. ???.
In a previous Thread I used Sandpaper discs, which IMHO actually did a better job.
I only had to use the 1 Disc, whereas I went through 8 Discs of Sandpaper, & about the same time.
All in All, it was a good job, as the Blade Cuts Straight & is Sharp, & that was what I was after.
I think I will go back to the Sandpaper, just to see if it really was a better job.