Hi all,
I need to cut a 110mm wide roll of aluminium flashing into two 55mm strips.
The roll is approx. 125mm dia.
Was thinking of making an old fashioned wooden mitre box of suitable size and cutting the roll with a fine toothed saw.
Final width of each strip is not really critical but close to 55mm would be good. Obviously this will depend on the width of saw used.
A slow and gentle approach what I am after.
Any thoughts or suggestions?
The 'highly trained' youth in my local Bunnings said I should just line it up in a drop saw and "let it rip".
Could get nasty !!!
Regards, Peter