Notch Weatherboard- Best method
Hi all,
I'm looking to clad a couple of bay windows on my Queenslander with notched weatherboards. Only problem is no one in Brisbane seems to sell these anymore.
With this being the case I thought I would have a go at making them myself using my spotted gum standard angle profile weatherboards.
How would one best achieve this look using a router? I have a triton router and a router table. I thought about using a V-Groove bit but I think that will leave a rounded bottom.
The only thing I can really think of is to somehow exit the cut on some kind of ramp/slant type jig to get the point of the V to 'drag out' if you will.
The bottom (thickest) part of the board is 25mm.
Any suggestions greatly appreciated.
https://i2.wp.com/healysbuilding.com...TAIL.jpg?ssl=1
https://www.coldstreamtimber.com.au/...are-Edge-1.png