Hi guys,
Here's a Baron II from our mate Dave at TBs. I used the Baron tube to sleeve the Sierra PCB blank and think it turned out ok.
It did touch one of the tallest bits on the PCB, but I sealed it with CA.
Hope you like it. :)
Printable View
Hi guys,
Here's a Baron II from our mate Dave at TBs. I used the Baron tube to sleeve the Sierra PCB blank and think it turned out ok.
It did touch one of the tallest bits on the PCB, but I sealed it with CA.
Hope you like it. :)
Wow that looks great:2tsup:
Well done.
Great stuff Skip, well done.
turned out a bit better than OK mate, that is a pearler
i haven't seen that circuit board blank design before, it really suits the gold plating on the baron components
thanks for showing
MIK
Another beaut :2tsup:
I assume the cap is from a resin blank? Shame a PCB blank isn't available large enough for the cap tube :-