Wanted: Turner near Hobart.

Hi, I am looking for someone to turn 70 balusters for a staircase in the Southern Tasmania region.

I am building the staircase but I am not set up for turning (also not efficient at it). I have a sample here that can be copied, and I can supply the blanks. They will be painted so will probably be in pine.

Since it is for a steep little staircase in a very old house the balusters will be very close together and I am looking for 32mm width, standard bought ones are 42mm which would look a bit bulky.

I also have 5 newel posts to turn in tas oak.

Is anyone here is interested in this little job or can you suggest someone?

Thanks, Bernt

From my observations there ain't too many Tasmanians that subscribe to this Forum so you might struggle to find someone here. However there's lots of woodturners in Tassie so you should have better luck elsewhere.

Kevin Morse lives in hobart he could help, look for KevM on the forum

Quote:

---

Originally Posted by Jim Carroll

Kevin Morse lives in hobart he could help, look for KevM on the forum

---

Thanks Jim, but not my cup of tea.

I'll ask around though and see if I can find any interest.

Not a lot of meat left on a 32mm square by the time it is turned though.

Thanks so far already,

I know there is not much meat left, the original stairs that ones have been removed had a going of about 190mm. I know that for the building code 250mm is minimum but there is only the space where the old ones once were. This means the balusters are much closer together then normal and since 19 mm is the minimum diameter for the spindles I think it will look a lot better if I use thin balusters.

I also have some here that are that size, they do look good.

I have been suggested one guy in Hobart, Faure, he has given me a price. I hope I can find someone who can do it a bit cheaper since his is out of my clients budget.

There are quiet a few woodturners at the local boatshed. I'll around when I'm back there on Monday night.

Hi, just a photo of what I am after, not in silky oak but in pine probably.

Bernt,

How long do the balusters have to be?

Quote:

---

Originally Posted by snowyskiesau

Bernt,

How long do the balusters have to be?

---

They need to be 1 meter long, the turned section is 600mm