Watch Parts - The Barons Mate

another watch parts this time on a siera, same basic design as the Baron II i showed a couple of nights ago

this was a test to see that i could make a siera watch parts without having to balloon it out in the middle, and yes it worked, back to the drawing board to increase the siera watch parts range, too much to do and work keeps getting in the way :-)

thanks for looking

C&C welcome

MIK

Very nice job there on the Sierra it looks great. The one question I have to anyone who reads this is without spending too much money what can I use to bend the watch parts without damaging the parts ?

Any advice would be good

Cheers Ian

Quote:

---

Originally Posted by Dorno

Very nice job there on the Sierra it looks great. The one question I have to anyone who reads this is without spending too much money what can I use to bend the watch parts without damaging the parts ?

Any advice would be good

Cheers Ian

---

i just use a piece of 4mm steel rod that i made a handle for to punch the rivet holes in the aluminum, it works well once you get the hang of it, i do break a few gears though, but thems the breaks, i did make a new tool today but i haven't yet had a chance to try it out

MIK