Chemical capsule hole okay a bit smaller?
I have the ramset M12 chemical capsules and anchor studs to fix my shed to a slab.
Capsule link - Ramset Australia
Anchor link- Ramset Australia
Would there be any problems drilling a 13mm hole in my slab to insert the capsule and anchor rather than a 14mm hole as recommended per the instructions? The capsules are 12mm in diameter and the anchor stud are also 12mm diameter (I measured them).
The pre drilled holes in my footing plates is just under 14mm and it won't allow my 14mm masonry bit through. I wanted to erect the frame on the slab first and drill the slab holes with the frame in place. A 13mm masonry drill bit should fit through the plate holes. I'd rather not setup the frame, mark holes, then remove frame again.