Pinecone Sphere

Printable View

1st February 2020, 06:04 PM
xeroxa

1 Attachment(s)

Pinecone Sphere

Today I show you how I made an epoxy resin sphere. It's basically trapped pine cones inside of the epoxy, formed so it has a small stand.
After it all hardened, I sanded it down to 500 grit. Afterwards i used my own sanding paste for the finish.

YouTube

Hope you enjoy it

best regards

Roger
Attachment 468082

All times are GMT +11. The time now is 08:08 AM.

Search Engine Optimisation provided by DragonByte SEO v2.0.42 (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Copyright © U-Beaut Enterprises 1999 - 2016. All rights reserved.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.