colour matching glue

Printable View

3rd May 2010, 01:05 PM
tg04se

colour matching glue

G'day, im just after any ideas on colour matching glue for pearl inlays in blackwood. I've used titebond mixed with blackwood dust and also araldite mixed with blackwood dust but both come up significantly darker than the timber when sanded and also under shellac. Any ideas on how to get a better match would be appreciated.
3rd May 2010, 06:06 PM
auscab

IMG_4736.JPG Oxide Powders, good in pva , 2 pack glues and plasti bond, I mix and match with a test run ,if an important job let dry and see, and should be the same colour or darker,
regards Rob

All times are GMT +11. The time now is 01:52 AM.

Search Engine Optimisation provided by DragonByte SEO v2.0.42 (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Copyright © U-Beaut Enterprises 1999 - 2016. All rights reserved.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.