Home made dial indicator fittings
Been busy on and off knocking up a dial indicator stand and fittings ,the base is designed to clamp onto the Tee slot cross slide table of the Myford lathe .
I can also use these on my mill .
All of the parts are made from 316 stainless steel except for the square pieces.
The long bar with the hinge joint is part of a fine adjuster so you can move the dial up and down with a thumb screw .
Still have a way to go to finish the fine adjuster ,made a couple of more parts for it after it took the pics.
Sorry about the pic quality I had to use my mobile phone as my camera is in being repaired.
Kev