Hi am after a couple of new guinea rosewood slabs for a dining table need to be big enough to get a top 2000x1000 and would like to finish at 45-50mm thick.
Thanks Damo
Printable View
Hi am after a couple of new guinea rosewood slabs for a dining table need to be big enough to get a top 2000x1000 and would like to finish at 45-50mm thick.
Thanks Damo
Could be wrong but I reckon you are going to have trouble sourcing slabs.
A few timber places carry milled NGR though.
If you can't get NG Rosewood, try for Aust rosewood, it is just as beautiful
Greg
If all else fails I could sell you enough Q rosewood [acacia rhodoxylon] would make a lovely table.Greg
Shouldn't you be using Rimu or some other dirty Kiwi timber, Damo?
yeah I should be but I have NGR chairs made and rimu is too hard to get over here.
Endeavour Timber Products supplies NG rosewood slabs. I get all of my timber from there.
Address: 55 Frederick st Northgate Qld 4013
Ph: (07) 3260 5500
Email: [email protected]