Finish raw NGR kitchen cabinet doors
Hi -- I'm planning to finish some solid timber kitchen cabinet doors (NG Rosewood) that I've ordered from a cabinetmaker. I've done a bit of reading in this forum, and I just thought I'd ask to see if I'm the right track...
For a sanding sealer, I was thinking of using a thin shellac sealer.
For the finish, I was thinking of using a satin oil-based single pack polyurethane, such as Cabots CFP (actually a floor poly, but at least one forum member likes it for furniture as well).
I don't have spray equipment, so I was planning to use a brush. The self-leveling properties of a floor poly would seem to make this a reasonable way to go.
I was thinking two coats of poly on top of the sanding sealer should about do it (sanding between coats).
Any comments or suggestions on this plan?
Thanks for your advice.