Does anyone know how to DELIBERATELY get a satin or flat finish using CA???
Many thanks, artme.
Printable View
Does anyone know how to DELIBERATELY get a satin or flat finish using CA???
Many thanks, artme.
All I do is gently rub the blank lengthwise with extra fine steel wool to get the semi-gloss or satin finish I want.
Works great.
Les
Attachment 342000
I remember seeing on the IAP where Johnathon Brooks was using a butane flame to take the shine off a CA finish. It looked good.
Here is a link to the method I mentioned
http://www.penturners.org/forum/f13/...-again-110596/
I would do it Les's way a lot safer.:2tsup:
I use exactly the same method as super glossy CA finish (sand to 600 grit, put on multiple coats of thin CA, polish with micro-mesh).
The only difference is I stop after the first couple of grades of micro mesh. Still has a great quality finish, but more satin and subdued than a super high gloss.