Hello Fellow Woodies,
I have a Stanley No220 block plane on which I stripped cleaned & oiled blade adjusting mechanism, upon reassembly the screw rotates freely but the adjuster block does not move on the ramp. I think that I must have assembled in the wrong sequence.
Does anybody have any suggestions on how to fix it?
Thanking You
Gerard
Doesn't that one have a blade with little notches on the bottom? And there's an elongate hole in it so that it can slide forward and back around the screw?
If it's the same one I've seen I think it's just a matter of making sure that the blade notches are down and one of them is engaged with the little slider thing that's driven by the screw, and then rotating that little toggle to lock down the lever cap and it should work.
Photos might help if that doesn't solve the problem.
Cheers,
Luke
Some pics may help us help you
Thank You Luke,Quote:
Originally Posted by Luke Maddux
The actual problem is that "the little slider thing" does not move when the adjuster screw is rotated. I shall give my camera a run and post photos this evening
thanks
Gerard
Gerard
Are u missing http://uploads.tapatalk-cdn.com/2016...22c4d92722.jpg
Are you missing the brass adjustment lever
Matt